I made a 3-level indoor large rabbit hutch using a KALLAX storage unit from IKEA.
- KALLAX Shelving unit, white stained oak effect, 112×147 cm
- PVC pipe
- Wire netting
- Angle brackets
- Wood board (large enough to cover the back of the KALLAX)
- Silicone sealant
Instructions for DIY large rabbit hutch
First, I used a jigsaw to saw the holes on the shelves before assembling the unit. As for the size of the holes, I based them on the diameter of the PVC pipe I was going to use in Step 2.
Second, I cut short pieces of PVC piping to reinforce the holes. These, I glued and siliconed into the holes.
Then, I assembled the KALLAX unit as per instructions.
For the front, I nailed the mesh with galvanised nails.
The bottom level
At the bottom level, where I placed the KALLAX door inserts, I sawed a hole at the side of the insert to allow an opening for the PVC pipe.
Then, I assembled the doors on the bottom as per IKEA instructions.
For the back, I drilled holes into two aluminium angles at the top and bottom, so I can slide in a piece of wood. This is so I can easily slide the back open for cleaning. I then screwed the angles to the top and the bottom.
Not pictured here yet but I am going to connect the PVC hoses between top floor holes to ensure there isn’t too much of a drop when jumping down a level.
Alternatively you could make the holes in the middle on the top floor off to the side so they don’t fall down a hole when jumping to the next section.
Hope the rabbit hutch is large enough for my bunnies.
~ by Abigail
The post Large rabbit hutch: A simple DIY project for your bunny appeared first on IKEA Hackers.